Burn A Cd
Linux

To burn a cd you use the command cdrecord. First find out the bus with the following command:

cdrecord -scanbus
scsibus4:
        4,0,0   400) *
        4,1,0   401) 'PLEXTOR ' 'DVDR   PX-760A  ' '1.06' Removable CD-ROM
        4,2,0   402) *
        4,3,0   403) *
        4,4,0   404) *
        4,5,0   405) *
        4,6,0   406) *
        4,7,0   407) *

After that go into the directory where the iso is located and give the following command
cdrecord -v -pad speed=1 dev=4,1,0 src.iso

Then it will burn the cd and outputs:
wodim: No write mode specified.
wodim: Asuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
TOC Type: 1 = CD-ROM
scsidev: '4,1,0'
scsibus: 4 target: 1 lun: 0
WARNING: the deprecated pseudo SCSI syntax found as device specification.
Support for that may cease in the future versions of wodim. For now,
the device will be mapped to a block device file where possible.
Run "wodim —devices" for details.
Linux sg driver version: 3.5.27
Wodim version: 1.1.9
SCSI buffer size: 64512
Device type : Removable CD-ROM
Version : 5
Response Format: 2
Capabilities :
Vendor_info : 'PLEXTOR '
Identification : 'DVDR PX-760A '
Revision : '1.06'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM)
Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr).
Driver flags : MMC-3 SWABAUDIO BURNFREE VARIREC FORCESPEED SPEEDREAD
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1190112 = 1162 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
Drive DMA Speed: 41353 kB/s 234x CD 29x DVD
FIFO size : 12582912 = 12288 KB
Track 01: data 689 MB padsize: 30 KB
Total size: 791 MB (78:24.37) = 352828 sectors
Lout start: 791 MB (78:26/28) = 352828 sectors
Current Secsize: 2048
ATIP info from disk:
Indicated writing power: 4
Is not unrestricted
Is not erasable
Disk sub type: Medium Type A, low Beta category (A-) (2)
ATIP start of lead in: -12508 (97:15/17)
ATIP start of lead out: 359845 (79:59/70)
Disk type: Short strategy type (Phthalocyanine or similar)
Manuf. index: 22
Manufacturer: Ritek Co.
Speed-Read is OFF.
New start of lead in: -12508 (97:15/17)
New start of lead out: 359845 (79:59/70)
Blocks total: 359845 Blocks current: 359845 Blocks remaining: 7017
Forcespeed is OFF.
Power-Rec is ON.
Power-Rec write speed: 48x (recommended)
Speed set to 706 KB/s
Starting to write CD/DVD at speed 4.0 in real TAO mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Waiting for reader process to fill input buffer … input buffer ready.
Performing OPC…
Starting new track at sector: 0
Track 01: 689 of 689 MB written (fifo 100%) [buf 99%] 4.2x.
Track 01: writing 30 KB of pad data.
Track 01: Total bytes read/written: 722556928/722587648 (352826 sectors).
Writing time: 1184.884s
Average write speed 4.0x.
Min drive buffer fill was 99%
Fixating…
Fixating time: 66.120s
Last selected write speed: 4x
Max media write speed: 48x
Last actual write speed: 4x
BURN-Free was never needed.
wodim: fifo had 11381 puts and 11381 gets.
wodim: fifo was 0 times empty and 11181 times full, min fill was 97%
Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License